The color change spools are created in our production when the color changes. The color is created purely randomly from the corresponding color change. No color can be chosen.
The use of high-quality raw materials creates a 3D printer filament that is particularly easy to process. Very low manufacturing tolerances are achieved using a state-of-the-art manufacturing process, which leads to convincing printing results for all FDM 3D printers. Each spool is sealed in a high-quality bag.
- Made in Switzerland
- low diameter and roundness tolerances
- easy to print
In general, PET-G is characterized by clarity/transparency, odor neutrality and robustness.
PET-G is still very easy to print, there are no significant problem areas. These properties, together with the high impact resistance, excellent flexibility and shrinkage values that are close to zero, make PET-G an excellent material for FDM 3D printing.
There is just one very important point to consider before processing. PET-G must be well pre-dried to prevent the material from forming bubbles and decomposing during processing. This fact also affects the storage of used filament rolls. These must be stored in a dry and airtight manner (humidity alone can significantly deteriorate the filament). It is recommended to add small drying bags (silica) to the packaged roll. If it is noticed during processing that the filament is "damp", it can be dried in an oven at 80°C for 2-4 hours, for example. This filament meets the composition requirements of European Regulation No. 10/2011 on plastic materials for contact with food.
Properties:
- Great hardness, strength and excellent rigidity
- Good toughness even in the cold
- Low coefficient of friction, high abrasion resistance
- Application range from -40°C to +100°C
- Good electrical insulation properties
- High tracking resistance
- Physiologically safe
- PET is resistant to stress cracking
- Weather and hot air resistant
- Flammable
- PET is resistant to water at room temperature, diluted acids, neutral and acidic salts, alcohol, ether, oils, fats, perchlorinated, aromatic and aliphatic hydrocarbons
- PET is not resistant to alkalis, superheated steam, ketones, phenols, esters, oxidizing acids and chlorinated hydrocarbons
Material: PETG
Diameter: 1.75 +/- 0.05mm
Weight: 1kg
Nozzle temperature: 210-260 ° C
Printing table temperature: 50-80 ° C
technical datasheet DE 372/Materialdatenblatt PETG purefil.pdf